Task 1: Cutting Wire to Length, Crimping Lugs
Using power wire cutters, strippers, and crimpers
| Energy / Category |
Hazard Description |
Risk Level |
Mandatory Control Measures |
|
Cut by/Punctured by
|
Cut or pinch by blades or jaws |
Moderate (Score: 20) |
Guard on power crimpers. Ensure hands are clear of cutter blades and crimper jaws |
|
Struck-by, Struck-against
|
Wire cutting and stripping can send cut wire ends airborne striking the eyes |
Moderate (Score: 18) |
Safety glasses with side shields |
Task 2: Torquing Wire Connections
Use Desoutter tool to torque wire connection
| Energy / Category |
Hazard Description |
Risk Level |
Mandatory Control Measures |
|
Ergonomics/Over-Exertion
|
Squeezing tool too hard with wrong body mechanics can place strain on soft tissue |
Moderate (Score: 16) |
Hold tool with enough pressure to maintain control but without excess tension in hands. Perform reverse stretching every 20-minutes if frequent torquing is required |
Task 3: Transferring panel to next station
Remove roller lock and lower gate. Roll the panel to the next station or transfer conveyor.
| Energy / Category |
Hazard Description |
Risk Level |
Mandatory Control Measures |
|
Struck-by, Struck-against
|
Conveyor pushed off conveyor |
Low (Score: 6) |
Verify conveyor being transferred to has gates up to prevent it from rolling off the edge |
|
Caught-in/Caught In-between
|
Fingers pinched between conveyor roller and panel |
Low (Score: 4) |
Move panel by holding on top of panel, not the edges. Manual conveyor so control remains with operator. |